hybrid operation, maintenance and warranty manual - Steyr Motors

CLEAN EFFICIENT POWER1. Move throttle lever into idle position and gear in neutral position.2. To stop E-Mode operation following two variants exists:VARIANT A:1. Push button „E-Mode“ on Hybrid panel to engage Diesel engine and Hybrid Generator (see below illustration)E-ModeManualDrive12 VStartE-ModeManualDrive12 VStartE-ModeManualDrive12 VStartE-ModeManualDrive12 VStartCLEAN EFFICIENT POWER11-022CLEAN EFFICIENT POWERNOTE:If button “E-Mode” on Hybrid panel is pushed during Hybrid-Generator is turning, the electrical propulsion isautomatically stopped and Diesel Engine will be engaged with Hybrid Generator.To start Hybrid Engine in D-Mode, bring throttle- lever in neutral position and continue with starting- process ofD-Mode as described (see chapter 2.3)11 0252. SCC displays under menu „HCU” following screen:STEYR-CONTROL-CENTERR49.16.45N 48.08.56N 102.41.11W 014.27.47W 57,4 117 14:05 22:57GENER.SPEED/KN10.0 3410,51,5 rpm0212 3rpm x 1000A2502509870 131E-Speed HCU/CUR045RPM2650 150050V010048,00BATTERYHybrid statustus55 3 4 43 85 4 85E-Mode ready26 °C bar 525D-Mode ready °C °C20 1090 68 HCU ok15050 120 6 120HCU2,8 6.377.8 E-MOTOR 73OIL/BARTEMP/°CMAINSWITCHGENER.Hybrid statusE-Mode readyD-Mode readyHCU ok11-013NOTE: D- Mode ready = green illustrated3.Turn ignition key to “OFF” position to switch the system OFFor Start Hybrid engine in D-Mode (see chapter 2.3)Z001045-0_1_March 2012 - 27 -