hybrid operation, maintenance and warranty manual - Steyr Motors

3 442651023 854512060200,51551,52902500CLEAN EFFICIENT POWER25005050851001201.To start the Hybrid- engine in E-MODE, move throttle lever into idle position and gear into neutral position.2.Turn ignition key into position ignition "ON".An audible alarm will sound (0,7sec.) and the warning lights are illuminated (temporary), indicating the correctfunction of the audible and visual warning systems.0,7 secOFFON0,7 secSTART0,7 sec11-031NOTE:In case of a low temperature start, wait until the combined oil pressure/glow plug pre-heating indication light isturned off, then continue with the start procedure.3.Wait till SCC has completely started up showing below screen- menu “Main”STEYR-CONTROL-CENTER49.16.45N 48.08.56N 102.41.11W 014.27.47W 57,4 117 14:05 22:57HCUHCUSPEED/KN10.0 3412 3rpm x 10004RPM2650 1500MAIN05SWITCH2103 4 43 85 46bar 52 °C 568 1502,8 6.377.8 73OIL/BARTEMP/°C120 611-0344.Select on SCC menu “HCU” to enter below shown screen.STEYR-CONTROL-CENTER49.16.45N 48.08.56N 014.27.47W 102.41.11W 57,4 117 14:0522:57SPEED/KN10.0 34012 3rpm x 100045bar °C86 1502,8 6.377.8 73OIL/BARTEMP/°CRPM2650 1500HCUMAINSWITCHSTEYR-CONTROL-CENTERR49.16.45N 48.08.56N 102.41.11W 014.27.47W 57,4 117 14:05 22:57GENER.SPEED/KN10.0 34rpm12 3rpm x 1000A9870 131E-Speed HCU/CURHybrid statustus45RPM2650 15003 4 43 85 4E-Mode ready26 °C bar 525D-Mode ready °C °C1068 HCU ok150120 6HCU2,8 6.377.8 E-MOTOR 73OIL/BARTEMP/°CV48,00BATTERYMAINSWITCHGENER.Hybrid statusE-Mode readyD-Mode readyHCU ok11-01311-032Z001045-0_1_March 2012 - 23 -