hybrid operation, maintenance and warranty manual - Steyr Motors

Check following parameters on screen „HCU” before continuing with start- procedure:- E-Mode ready= red illustrated,- D-Mode ready= green illustrated,- HCU o.k.=green illustrated- GENER.= green illustrated,- BATTERY= between min.45V/max.57V .NOTE: If parameters are not displayed as described above, follow chapter chapter 4.TROUBLE SHOOTINGor contact your authorized STEYR MOTORS marine DEALER.5. Press the button START (ill.G; green) and hold in this position until "starting" of engine, but under nocircumstances hold in this position for more than ten seconds.If engine does not start, release start – push button momentarily and repeat starting procedure.ATTENTION: If Hybrid- engine is not to start, in emergency cases conventional startermotor can beused for start- up. To start the Hybrid- engine with conventional startermotor refer to chapter 2.5(STEYR MOTORS recommends to use conventional starter- motor only in emergency- cases. If conventionalstarter-motor is used, contact authorized STEYR MOTORS DEALER for fault investigation as soon as possible)6. As soon as engine starts, release start button. The audible alarm will stop when normal oil pressure hasbeen reached.ATTENTION: If engine fails to start within one minute and/or repeated attempts, try to start in emergency caseswith conventional startermotor (proceed according chapter 2.5) or contact your STEYR MOTORS Marine dealer.Never push start button when engine is running.STOPPING HYBRID ENGINE in D-MODE (for SOLAS only)1. Move throttle lever into idle position and gear in neutral position.2. Cool down the engine.3. Press push button ignition ON/OFF (ill.F) to disengage from locking position and to shut OFF the engine.ATTENTION:Do not stop engine at speeds above idle or accelerate engine while turning off ignition. This may result inengine failures.Z001045-0_1_March 2012 - 21 -