hybrid operation, maintenance and warranty manual - Steyr Motors

3 4 42651023 85 45120 60200,51551,52902500CLEAN EFFICIENT POWER25005050851001201.To start the Hybrid- engine in E-MODE, move throttle lever into idle position and gear into neutral position.2. Press the push button for ignition (ill.F;red) (push button lock in place); An audible alarm will sound(0,7sec.)and the warning lights are illuminated (temporary), indicating the correct function of the audible and visualwarning system.STARTONOFF11-041NOTE:In case of a low temperature start, wait until the combined oil pressure/glow plug pre-heating indication light isturned off, then continue with the start procedure.3.Wait till SCC has completely started up showing below screen- menu “Main”STEYR-CONTROL-CENTER49.16.45N 48.08.56N 102.41.11W 014.27.47W 57,4 117 14:05 22:57HCUHCUSPEED/KN10.0 3412 3rpm x 10004RPM2650 1500MAIN05SWITCH2103 4 43 85 46bar 52 °C 568 1502,8 6.377.8 73OIL/BARTEMP/°C120 611-0344.Select on SCC – menu “HCU”“ to enter below shown screen.STEYR-CONTROL-CENTER49.16.45N 48.08.56N 014.27.47W 102.41.11W 57,4 117 14:05 22:57HCUSTEYR-CONTROL-CENTERR49.16.45N 48.08.56N 102.41.11W 014.27.47W 57,4 117 14:05 22:57GENER.SPEED/KN10.0 34012 3rpm x 100045bar °C6 8 1502,8 6.377.8 73OIL/BARTEMP/°CRPM2650 1500MAINSWITCHGENER.SPEED/KN10.0 34rpm12 3rpm x 1000A9870 131E-Speed HCU/CURHybrid statustus45RPM2650 15003 4 43 85 4E-Mode ready26 °C bar 525D-Mode ready °C °C1086 HCU ok150120 6HCU2,8 6.377.8 E-MOTOR 73OIL/BARTEMP/°CV48,00BATTERYMAINSWITCHHybrid statusE-Mode readyD-Mode readyHCU ok11-03211-013- 30 -Z001045-0_1_March 2012