iE2820 - Permo Electronics

15 GPS/GPS-A OPERATIOND GPS alarm settingGPS alarm sounds when your own position is close the specifiedarea. This function can be set the received channel,specified GPS memory channel, all GPS memory channelsor a memory bank.qPush [GMR](TONE•DTMF) to select GPS memory mode.wRotate [DIAL] to select the desired memory group, ormemory channel.• “RX,” “ALL,” one of memory bank or memory channel can be selected.ePush [ALM](TONE•DTMF) to turn the alarm function ON.• Push [ALM](TONE•DTMF) again or push [Aoff](LOW•PRIO) toturn OFF the alarm function.D GPS memory clearingqPush [GMR](TONE•DTMF) to select GPS memory mode.wRotate [DIAL] to select “ALL,” or desired memory bank,then push [MAIN•BAND].eRotate [DIAL] to select the desired GPS memory channel•“ALL” or one of memory bank can also be selected.NOTE: When selecting “ALL” or one of the memory banks,all memory channels or all memory channels in the specifiedmemory bank are cleared, respectively.rPush and hold [CLR](DUP•MONI) for 1 sec. to clear.•3 beeps sound, then the memory channel is cleared.• Remaining channels scroll up.tPush [BACK](V/MHz•SCAN) (Right band’s) twice to returnto frequency indication.NOTE: Be careful!— the contents of cleared memoriesCANNOT be recalled.rPush [BACK](V/MHz•SCAN) (Right band’s) once or twice toreturn to frequency indication.127✔ For your information!• When “ALL” or memory bank is selected above step w, thealarm functions depending on “ALM AREA1” setting in theGPS set mode (p. 110).• When “RX” or memory channel is selected above step w,the alarm functions depending on “ALM AREA2” setting inthe GPS set mode (p. 110).