iE2820 - Permo Electronics

1 PANEL DESCRIPTION■ Main unitq wer teGPS ANTENNA CONNECTOR [GPS ANT] (p. IV)When the optional digital unit, UT-123, is installed, connectsthe GPS antenna supplied with the optional UT-123.rPACKET JACK [PACKET] (pgs. 118, 119)Connects a TNC (Terminal Node Controller), etc. for datacommunications. The transceiver can support 1200/9600bps packet communication (AFSK/GMSK).tMICROPHONE CONNECTOR [MIC] (p. III)Connects the supplied or an optional microphone.yu i o !0qCONTROLLER CONNECTOR [CONTROLLER] (p. III)Connects the controller unit with the supplied controller orseparation cable.wDATA JACK [DATA] (p. 57)Connect to a PC via the optional data communication cableOPC-1529R for data cloning with the optional cloning software,CS-2820, or low-speed data communication in DV*mode operation.*Available only when the optional UT-123 is installed.!1iqq +8 V DC output (Max. 10 mA)w Channel up/downe 8V control INr PTTt GND (microphone ground)y MIC (microphone input)u GNDi Data INyANTENNA CONNECTOR [ANT1 TX/RX] (p. IX)Connects a 50 Ω antenna with a PL-259 connector and a50 Ω coaxial cable for transmission and reception.uCOOLING FANRotates while transmitting.Also rotates while receiving depending on the setting in setmode. (p. 99)9