iE2820 - Permo Electronics

DV MODE OPERATION (Optional UT-123 is required)5D One-touch replyqAfter receiving a call, push [F• ] twice to display thefunction guide 2.wPush [R>CS](TONE•DTMF) to set the received call sign asfor the call.[R>CS]D One-touch reply using the call recordThe stored call signs in the call record can be used to the call.qPerform the steps q and w of “D Desired call record indication”described on the previous page.➥ When selecting a call record via MENU screen:wPush [MAIN•BAND] to display the call record details.ePush [R>CS](V/MHz•SCAN) (Left band’s) to set the receivedcall sign to that of the call record.➥ Setting from function guide 2:wPush [R>CS](TONE•DTMF) to set the received call sign tothat of the call record.After the above operations, push [PTT] to transmit; releaseto receive.NOTE:• Set your own call sign (MY) in advance. (p. 39)• The call sign stored in “CALLER” is stored as “YOUR,”“RXRPT1” is stored as “RPT2” and “RXRPT2” is storedas “RPT1.”• Error beeps sound when a call sign is received incorrectly,and no call sign is set in this case.Important!Setting call signs with the “One-touch reply using the callrecord” operation as at left are for temporary operation only.Therefore, the set call signs will be overwritten when anothercall record is used to set call signs.• Never save into a call sign memory.If you want to save the set call signs, see “Copying the callrecord contents into call sign memory” (p. 50) for details.✔ For your informationWhen a call specifying your call sign is received, the call signsof the calling station and the repeater it is using can be usedfor operation automatically.• When “RX call sign auto write” (p. 101) is set to “AUTO,” thestation call sign in “CALLER” is set to “YOUR” automatically.• When “Repeater call sign auto write” (p. 102) is set to“AUTO,” the stored station call sign in “RXRPT1” is storedas “RPT2” and “RXRPT2” is stored as “RPT1” automatically.1234567891011121314151617181948