iE2820 - Permo Electronics

6 MEMORY MODE OPERATION■ Programming a memory channelVFO settings, including MENU group contents such as subaudibletone frequency and offset can be programmed into amemory channel.qSet the desired frequency in the desired band (left or right).➥ Push the desired band’s [V/MHz•SCAN] to select VFOmode.➥ Set the frequency using the same band’s [DIAL].➥ Set other data (e.g. tone frequency, duplex information, etc.)if required.wPush and hold the same band’s [M/CALL•MW] for 1 sec.•2 beeps sound•“X” indicator and the memory channel number blink.eRotate the [DIAL] to select the memory channel to be programmed.• Memory channels not yet programmed are blank.rPush and hold [S.MW](M/CALL•MW) (Left band’s) for 1 sec.to program.•3 beeps sound• Memory channel number automatically increases when continuingto push [M/CALL•MW] after programming.✔FOR YOUR ONVENIENCEMemory programming can be performed in various ways e.g.memory channel to the same (or different) memory channel,memory channel to the call channel, etc.[EXAMPLE]: Programming 145.870 MHz into memory channel 20 (blank channel) via the controller.RotatePush SCAN Rotate for setting frequency, etc. Push and hold MW for 1 sec.M AINV/MHzB A N DM AINB A N DS.MWM/CALLM/CALLPush and hold MW for 1 sec. and continue to push ➠““Beep““BeepBeepBeep““““Beep“““Beep61