nbdp terminal dp-6

5. Press the [ ] key to advance the cursor to the Start Time line.Enter start time in 24-hour notation. To have the operation startat 8:35, for example, the keying sequence would be;[0] [8] [3] [5] [0] [0]6. Press the [ ] key to advance the cursor to the Stop Time line.Enter stop time.7. Press the [ ] key to advance the cursor to the Receive/Sendline. Select operation category; Receive or Send.8. For send, insert floppy disk in drive and designate the file tosend. Press the [ ] key to advance the cursor to the File toSend line. Press the [ ] key to display the file list, select a file,and press the [Enter] key.9. Press the [Enter] key.10. Press the [Enter] key. The operation name appears in the TimerOperation List. See note 2 and 3.Note 1: To change a timer program, select it on the Timer OperationList, select Change and press the [Enter] key. Enter new data.Note 2: If the operation name entered already exists, the displayshows the following message: Operation name already exists. Pressany key to escape. Press any key and change the operation name.Note 3: If the station name entered has not been registered, thedisplay shows the following message: Station by that name doesnot exists. Press any key to escape. Press any key and register thestation as shown on page 3-3.Editing/Deleting Timer Programs1. Press function key [F5] and the [2] key.2. Select timer program from the Timer Program List.3. Select Change and press the [Enter] key.4. Do one of the following;Edit program: Use [ ], [ ] and the [Backspace] key tomake corrections.Delete program: Erase operation name with the [Backspace]key.5. Press the [Enter] key twice.6. Press the [Esc] key.3-6