nbdp terminal dp-6

3.4 Scan Channel GroupsThe DP-6 can automatically control radio equipment through channelscanning. The radio equipment scans a number of channels(according to your selection), stopping when your own ID code isdetected in an incoming signal. The transmitter is tuned to the correspondingtransmitter frequency, the communication link is establishedand the traffic is automatically exchanged. Scanningresumes once the link is disconnected.You may store a maximum of 10 scan groups, 20 channels pergroup. Note that scanning is only possible in the ARQ and FECmodes.Registering Scan Channel Groups1. Press function key [F5] followed by the [3] key to display theScan Entry screen.Scan EntryScanning Group ListCreateChangeScanning Set UpGroup Name :Ch Dwell Time : 4.5 sec (2.7-4.5 sec)Mode : AUTO ARQ FECAuto Search : OFF ONNo Channel Rx Freq Tx Freq Pass/Scan12345Pass/ScanPass/ScanPass/ScanPass/ScanPass/Scan▼ 6Figure 3-8 Scan entry screen2. If Create is not underlined, press [ ], [ ] and the [Enter] keyto underline it.3. The cursor is on the Group Name line. Enter suitable groupname.4. Press the [ ] key to advance the cursor to the CH Dwell Timeline. Enter channel dwell time in seconds. Dwell time is thetime in seconds the receiver waits on each channel in a scangroup before it selects the next frequency.3-7