nbdp terminal dp-6

1:File 2:Edit 3:Operate 4:Window 5:Station 6:System 7:WRU 8:HR 9:Over 10:Break1996-11-15 14:28 (JST) CapsStation Name : CHOUSHI-8MFrequency (T/R) : 8765.00 / 8965.00(kHz) Comm Mode :ARQComm Status : Connect Send Lock ErrorSending Volume : 100(%) ARQ Error : 0 ARQ Time : 0(sec)Figure 5-9 Communication status displayType a message from keyboardAfter exchanging answerback code by the function key [F7](WRU) and [F8] (HR), type your message directly from thekeyboard.5. To change direction of traffic, press either function key [F9](OVER), or [+] and [?]. Then, the other station becomes theinformation sending station, your station the information receivingstation.6. Receive a message from the sending station, if any.7. After completion of communication, press function key [F7](WRU) key to receive the answerback code of the other stationand then press function key [F8] (HR) key to transmit yourown answerback code.8. Press function key [F10] (BREAK) to disconnect the line.5.6 FEC Mode OperationThe FEC method of error correction is used when there is morethan one receiving station, and no replies are required by the otherstation. Each message is sent twice, the characters of the first messageinterleaved with those of the second. The receiving stationthus has two chances to receive each character correctly. If bothcharacters are in error, an asterisk (*) is printed.1. Press function key [F3].2. Press the [1] key to display the Call Station menu.You can select scan group by scan table.3. Select a station which is registered for the FEC mode. Pressthe [Enter] key. CONNECT lights in inverse video.4. Transmit message from a floppy disk as follows.Press function key [F3] and the [2] key to open the Send screen.Select file to send and press the [Enter] key.5. After the message is transmitted, press function key [F10](BREAK) to disconnect the line.5-7