nbdp terminal dp-6

5. Press the [ ] key to advance the cursor to Mode, and then selectthe communication mode; AUTO, ARQ or FEC.Note: To register the Scanning Channel Group for ARQ, selectARQ. For FEC, select FEC.AUTO is used to register scanning channel group when bothARQ and FEC exist in the same Scanning Channel Group.When you select scan group by call sration menu, set Mode toFEC (See Page 5-7).6. Press the [ ] key to advance the cursor to Auto Search. SelectAuto Search to ON or OFF.Auto Search ON:Radio stops scanning when it finds thestrongest signal (highest S/N ratio). Tofind strongest signal, the radio scans allthis channel, which may take some time.Therefore, use this setting where signalpropagation is poor.Auto Search OFF: Radio stops scanning on the first signal itfinds. We recommend that you set AutoSearch to OFF where signal propagationis good.7. Advance the cursor to line no. 1 in the Scanning Set Up window.Enter channel number (ITU or user channels) and pressthe [ ] key to select "Scan".8. Press the [ ] key to advance the cursor to line No. 2. Enterchannel number.9. Enter other channel numbers and then press the [Enter] key.10. Press the [Enter] key again to save the data.To register another scan group, repeat steps 2 – 9.Note: When the scan group memory is full the DP-6 displays "Scangroup information full."Editing/Deleting Scan Channel Groups1. Press function key [F5] and the [3] key. Select scan group fromthe Scanning Group List.2. Select Change and press the [Enter] key.3. Place the cursor on the line (channel) to change.3-8