PNEG-1156ETL - David Manufacturing Co.

4. Assembly and InstallationCenter Suspension System1. The Center Suspension System: Double auger units use a single piece square tube. The tripleauger units use a two (2) piece square tube “T” assembly.2. For Double Auger Units: Place the attachment link on the single suspension tube into the weldedclevis provided on the yoke head. Fasten with one 1/2" x 2" hex head bolt and hex lock nut. Tightenwith ratcheting hand wrench. (See Figure 4AE.)Figure 4AE Double Auger3. For Triple Auger Units: First assemble two (2) piece “T” square tube sections using one 1/2" x 2"hex head bolt and hex lock nut. Tighten with ratcheting hand wrench. (See Figure 4AF.)Figure 4AF Triple AugerNOTE: Be sure small loops on the suspension tube ends are always down.36 PNEG-1156ETL Design III Series Grain Stir-Ator CSA