PNEG-1156ETL - David Manufacturing Co.

4. Assembly and InstallationTrack Gear Motor1. Cut lead-in wire loose from yoke pipe by cutting the zip tie. Be careful not to damage the wire.2. Unwrap gear motor wire from the yoke tube and strip the end. Remove the fuse cover from thejunction box using a phillips screwdriver. Insert wire through connector and connect the wire with fuseholder wires using yellow wire connectors. Replace cover assembly and secure the wire to the framerails with cord clips which push over the frame rail flange. Wire black to black, white to white andgreen to green. (See Figure 4AG.)Leveler DisksFigure 4AG1. Loosen the 1/2" x 2-1/2" bolts on the leveler disk. Slide into the stub shaft with the clamp portion up.Hold the leveler disk in position by placing the snap ring onto the stub groove cut into the stub shaftby tapping it with a hammer. (See Figure 4AH.)Figure 4AHPNEG-1156ETL Design III Series Grain Stir-Ator CSA 37