Brisque to Lotem 800 II / Lotem Quantum Family - Kodak

Defining the Store Parameters 85Defining the Store ParametersFront & Back PreviewLaunch Brisque Jobto Brisque TemplateDefine Plate ExposeparametersDefine Store parametersSubmit Job TicketEmergency plate remakeIn this section you will modify the Store parameters in the current JobTicket so that the Job elements (original pre-RIPped files, post-RIP files,and plate-mark files) are stored in one of the available storage modes.Initially, you store the Job in the On Press mode. The files are kept availablefor an immediate plate remake in the event of an unexpected plateemergency. After the entire Job is successfully exposed, you can move thestored Job to the Long Term mode.On Press storage normally lasts from several hours to days, and the Jobremains in an on-hold state until you release it by promoting the stored Jobto a higher Storage Mode status, or by advancing the Job to the next step inan automated Job Ticket workflow.Long Term storage allows you to store completed Jobs that do not requirefurther processing. You cannot perform a regular Brisque operation on aJob once it has been stored in the Long Term storage.Important: You can only perform a Quick Re-Expose on a stored Job that hasalready been through at least one plate exposure.Long Term StorageTo define the Store parameters on the fly:1. After exiting the Plate Expose dialog box, you return to the Job TicketEditor dialog box.