Brisque to Lotem 800 II / Lotem Quantum Family - Kodak

42 Chapter 2 – Configuring and Calibrating the Lotem 800 II / Lotem Quantum Family from the Brisque WorkstationTone ReproductionTone Reproduction curves are created to compensate for press-relatedeffects and to control image tonality.The curves are built according to data measured off the press andaccording to pre-calculated correction tables supplied by the printer. ToneReproduction Curves are not very different from Excurves, except that themeasured values are taken from the press and not from paper or media.The Tone Reproduction application on the Brisque lets you create, modifyand delete Tone Reproduction curves and then apply a Tone Reproductionto your exposure.Note: Before you begin the Tone Reproduction procedure, make sure that theExcurve calibration has been performed and is correct.Creating a Tone Reproduction CurveYou can create a new Tone Reproduction curve in one of two ways:• Create a curve from scratch• Modify an existing curve, then save it under a new name.To create a new Tone Reproduction curve from scratch:1. From the Brisque Launch Pad, double-click the Devices icon. TheOutput Devices Handling window opens.2. From the Output Devices Handling window, click the arrow next to adevice type, then click the arrow next to a device.3. Select a device configuration; the device operations are enabled.4. Click Tone Reproduction. The Tone Reproduction Curve List dialogbox opens.