Brisque to Lotem 800 II / Lotem Quantum Family - Kodak

120 Chapter 5 – Proofing a Job on the Lotem 800 II / Lotem 800 II Quantum with Spectrum from the Brisque(0,0) Top Left(0,0) Top CenterAroundthe DrumDrumReceiverAlong theDrumNote: The selected value is used as the [0,0] reference offset points on thereceiver relative to drum.2. In Offset, enter the value(s) by which to shift the Layout on theproofing media from the reference point (that is, Top-Left or Top-Center as defined in Alignment). Exposure will start at this point.3. In Fitting, select the relevant mode from the drop-down list.• Use Tiling for a Job that is larger than the receiver so the proof istiled over several receivers (in such a way that, in the final proof,they can be re-attached).• Use Clipping for a Job that is larger than the receiver so the proof iscropped to fit the receiver (in this mode, a part of the page is notexposed).4. In Orientation, select the rotation angle of the exposed image on theproofing media.• Clickorientation.for an Imposition Job or for a Job in landscape