Brisque to Lotem 800 II / Lotem Quantum Family - Kodak

Aligning Signature Elements 73Viewing Background Flat Through Foreground FlatWhen you first activate the Front and Back Preview mode, the flatdisplayed in foreground is superimposed over the flat in background.Initially, the degree of transparency is 0%, such that only areas of thebackground flat not covered by elements from the foreground flat can beseen. In this section, we describe how to set the degree of transparency.The following transparency modes are available (depending on your Viewmode):• Ghosting• MaskingTo activate ghosting or masking:Click the Transparency tool. To cancel ghosting/masking, click the toolagain.To increase the degree of ghosting (in Low Res Images and QuickPreview display modes):From the Preview Layout toolbar, click the Increase Ghosting tool.To decrease the degree of ghosting (in Low Res Images and QuickPreview display modes):From the Preview Layout toolbar, click the Decrease Ghosting tool.Aligning Front and Back Elements in a SignatureWhen ghosting or masking is activated, you can reposition Page and markelements so that the front flat is completely aligned with the back flat.Repositioning is only possible with elements on the foreground flat(bordered in gray) and moved in relation to the stationary elements in thebackground flat (bordered in black).Tip: To obtain a high level of accuracy when aligning elements, use a high zoominfactor, AND reposition the elements by dragging with the right mouse button(this is much faster than using the Parameters window to manually reposition theelements).