Contact Technical Support

CADC MessagesCADC521I — VERIFY RECEIVE: PATH=pathid1 : FOR=pathid2 : TIME=hh:mm:ssVERIFY SEND: PATH=pathid1 : FOR=pathid2 : TIME=hh:mm:ssReason:A special path verification record has been processed by this CPU. Normally if apath has been 'idle' for too long a period, a verify transaction would be sentalong this node's send path, specifying its receive path as the target. If the verifytransaction is then received, both paths have been verified as active, and bothnodes are assumed to be communicating.Action:None, this is an informational message produced when the PATH LOG ONpathid VERIFY command had been issued.CADC522E — VERIFY ERROR: SEND PATH=pathid1 : RECEIVE PATH=pathid2 : TIME SENT=hh:mm:ssReason:A special path verification record had previously been sent by this CPU, but ithas not been received on the corresponding path within the specified time limit.This indicates that an error exists in either of the two paths or communicatingnodes.Action:Ensure that the nodes are active. If active, then check for a prior CADC500Emessage in the console log.CADC523E — PLIST IN ERROR=address hex-dataReason:This message is produced after a CADC500E message and provides additionalinformation regarding an XSYSTEM function error.Action:None. This is produced when the PATH LOG ON pathid PLIST command isissued.3–50 Message Guide