Contact Technical Support

MFLINK Host Abend Codes (PCLx)PCL3Reason:There was an internal receive logic error that caused a packet length error. In anMRO environment, this can occur if the host application program and The IDAInterface Component transaction (ALKA/ALKC) are in different MRO regions.Action:You can correct this problem if it occurs in an MRO environment as describedabove. The host application program and the ALKA/ALKC transaction must bein the same MRO region. This is a matter of definition in the CICS table thatcontrols where a specific program is to run. If this problem does not occur in anMRO environment or if it persists, contact your Site Coordinator, who will callthe appropriate Product Support group.PCL4Reason:There is an internal asynchronous logic error that caused a packet number fromthe PC to be too high. This problem can occur if you are using an asynchronousdevice. In most cases, it means that excessive line noise corrupted The IDAInterface Component header information.Action:In general, this problem should not recur. If it does, contact your SiteCoordinator, who will call the appropriate Product Support group.PCL6Reason:There is an internal decompress logic error, which leaves no room to decompressa message.Action:Contact your Site Coordinator, who will call the appropriate Product Supportgroup. This is an internal error that cannot be corrected by the user.9–28 Message Guide