A-ISOMETER® IRDH375 IRDH375B - Bender

Safety informationThis operating manual, especially the safety information, must be observedabove all by personnel who work on the A-ISOMETER®.In addition, the rules and regulations that apply for accident prevention atthe place of use must be observed.1.2.1 PersonnelOnly appropriately qualified staff may work on the A-ISOMETER®. Qualifiedmeans familiar with the installation, commissioning and operation of theproduct and with training appropriate to the work.Personnel must have read and understood the safety section and warning informationin this operating manual.1.2.2 About the operating manualThis operating manual has been compiled with the greatest possible care.Nevertheless, errors and mistakes cannot be entirely ruled out. The BENDERcompanies assume no liability whatsoever for any injury to persons or damageto property which may be sustained as a result of faults or errors in thisoperating manual.1.2.3 Hazards when handling the A-ISOMETER® IRDH375The A-ISOMETER® IRDH375 is constructed according to the state-of-the-artand recognized technical safety rules. Nevertheless, when it is being used,hazards may occur to the life and limb of the user or third parties, or theremay be adverse effects on the A-ISOMETER® or on other valuable property.The A-ISOMETER® must only be used:• for the purpose for which it is intended• when it is in perfect technical condition as far as safety is concernedAny faults which may impair safety must be eliminated immediately. Impermissiblemodifications and the use of spare parts and additional deviceswhich are not sold or recommended by the manufacturer of the devices maycause fires, electric shocks and injuries.Unauthorized persons must not have access to or contact with theA-ISOMETER®. Warning signs must always be easily legible. Damaged or illegiblesigns must be replaced immediately.8 TGH1352en/11.2004