TE450 SM service manual.pdf - Hyosung

ELECTRICAL SYSTEM 6-185 Separation of electrolyte containerAfter confirming that you entered the electrolyte intobattery completely, remove the electrolyte containersfrom the battery.CAUTIONDraw the empty receptacle out slowly because theremay be a chance remaining electrolyte vaporize.6 Insert the capsInsert the cap into the filler holes, pressing it firmly sothat the top of the caps do not protrude above theupper surface of the battery’s top cover.◉ SERVICINGVisually inspect the surface of the battery container. Ifany signs of cracking or electrolyte leakage from thesides of the battery have occurred, replace the batterywith a new one. If the battery terminals are found to becoated with rust or an acidic white powdery substance,then this can be cleaned away with sandpaper.◉ RECHARGING OPERATION● Using the pocket tester, check the battery voltage.If the voltage reading is less than the 12.0 V (DC),recharge the battery with a battery charger.Insert the caps firmlyHow to chargeStandard0.8 A × 5~10 hoursFast4 A × 30 minutesCAUTIONWhen recharging the battery, remove the batteryfrom the vehicle.NOTEDo not remove the caps on the battery top whilerecharging.CAUTIONBe careful not to permit the charging current toexceed 4A at any time.● After recharging, wait for more than 30 minutesand check the battery voltage with a pocket tester.● If the battery voltage is less than the 12.5V,recharge the battery again.● If battery voltage is still less than 12.5V, afterrecharging, replace the battery with a new one.● When the vehicle is not used for a long period,check the battery every 1 month to prevent thebattery discharge.