AS-700

Pos: 101.4 /Bedienungsanleitungen/Geräte spezifisch/Drucker/Printer Driver & Cables to PC/USB 2.0 (619)/7.X.X_Ü3_How to identify the USB port number @ 3\mod_1296549141672_912.doc @ 29849 @ 2printer driver.The „Found New Hardware Wizard“ (see Figure 58) will appear eachtime the printer is turned on or plug into the PC. To avoid this youhave to install the printer driver version which is delivered togetherwith the printer.11.3.2 Ethernet connection1. Check theinstalledprinter driver2. Add aTCP/IP port tothe printerdriver3. Setup theEthernetconnection• Make sure that the already installed printer driver is the correctone for your new printer. For example the printer model AS-710requires the printer driver for the AS-710.• Add a “Standard TCP/IP Port” to the already installed printer driveras described in chapter 7.3.1, on page 89.• Setup the Ethernet connection between the printer and the PC asdescribed in 7.3, on page 88.11.4 How to identify the USB port used by the printerIn certain cases (e.g. further use of already installed printer drivers) it is necessary toidentify the exact USB port number, when the printer is connected to the PC via USB.As most PC’s nowadays have more than one physical USB port. The USB port number canbe used to identify the actual port where a device is plugged in.Depending on which PC USB port the printer is plugged in, the USB port number can be forexample USB001, USB002 or etc.1. Set theprinter to USBcommunication2. Connectingthe printer3. Devicedetection• Check if the printer is set to USB communication in the printermenu: PRINTER CONFIG. > BOOT DEFAULTS > COMMUNICATION• If not, set it to USB.• Connect the printer to the PC with the USB cable.• Turn on the printer.• Wait until Windows detects the printer.142 User Manual Version 3.1