AS-700

separation fingersFigure 11: Separation fingers2. Adjust thepaper sideguides• Loosen the fixing screws (C) of both paper side guides (see Figure12).• Move the two paper side guides apart.• Put in one medium in the feeder according to your desired printposition. Use the ruler to determine the position. Please note thatthe print directions NOR (Normal) and REV (Reverse) havedifferent zero positions (see Figure 13). For further informationabout the print direction please see chapter 5.6 „How to set theprint direction (orientation)”, on page 39.• Make sure that you medium covers the paper sensor. The positionof the paper sensor is indicated on the label with the scale (seeFigure 14).• Push the side guides back towards the medium.• The side guides should be close to the medium so that it cannotturn when it is pulled into the printer. But the side guides shouldnot clamp the medium.• Position the paper feed ramp in the middle of the two side guides.• See Figure 12 for an sample setup with a C5 envelope.Different material sizesThe optional available paper side guides for differentformats makes the feeding of these materials morecomfortable. Please see chapter 9.2, on page 132for further information.34 User Manual Version 3.1