AS-700

Pos: 62.2 /Bedienungsanleitungen/Geräte spezifisch/Drucker/Printer Driver & Cables to PC/7.X_Ü2_How to install and configure the printer driver_ONLY_619 @ 3\mod_1295280186142_912.doc @ 29403 @ 2337 How to connect the printer to the PCTo connect the printer to a PC, use either the USB interface or the Ethernet interface of theprinter. To connect the printer to a network, use the Ethernet interface.Independent from the interface (USB or Ethernet), it is necessary to install a printer driveron the PC that will be used to send data to the printer.Follow the installation proceduresPlease follow the installation procedures described in this chapter.Please stick to the order of installation steps (e.g connecting theprinter to the PC) as described in this chapter.• Please see chapter 7.1 on how to install and configure the printer driver.• Please see chapter 7.2 on how to use the USB interface• Please see chapter 7.3 on how to use the Ethernet interfaceThe printer will work either with the USB interface or with theEthernet interface. The two interfaces cannot be used together at thesame time.7.1 How to install the printer driver7.1.1 Windows XP and Windows Vista1. Insert thedriver CD-ROM• Insert the Neopost CD-ROM in the CD drive of your PC.2. Connect thePC to theprinter• Make sure that your printer is turned off.• Connect the printer with the USB cable to your PC.• Turn on the printer. Check if the printer shows OnlinUSB in thebottom line of the main display.If not press the Ok key to turn the printer online.If the printer shows OnlinTCP in the bottom line of the maindisplay use the menu PRINTER CONFIG. > BOOT DEFAULTS >COMMUNICATION to select the USB interface.• Wait for the automatic detection of the new hardware.• Proceed with the installation of the printer driver.User Manual Version 3.1 83