warning - Docs.hvacpartners.com

S Remove the relief tube from the condensate trap.S Remove the screw that secures the condensate trap to thecollector box.S Remove the trap.S Remove the relief tube from the port on the collector box. It isnot necessary to remove the tube from the inducer assembly.For Horizontal Left only:S Remove the pressure switch tube from the front pressure switchand discard the tube. A new pressure switch tube is shipped inthe loose parts bag.For Horizontal Right only:S The pressure switch tube location is not modified.S Loosen the clamp around the inlet of the vent elbow on theinducer.S Remove the plugs from the collector box and set aside. Do NotDiscard Plugs.For Horizontal Left only:S Remove the middle and right plug from the ports at the bottomof the collector box.For Horizontal Right only:S Remove the plug to the right of the condensate trap.S Refer to the appropriate figure to begin the trap conversion.S Install the plugs previously removed from the collector box inthe ports where the condensate trap was removed.S Install the trap over the ports on the lower side of the collectorbox.S Secure the trap to the collector box with the screw.S Connect the relief tube to the condensate trap to the relief port ofthe condensate trap.S If necessary, slide the relief tube in the inducer stand-offs toadjust the position of the tube.S Connect the relief tube to the relief port of the condensate trap.For Horizontal Left only:S Connect the new pressure switch tube to the port on the frontpressure switch. Route the tube through the stand-offs on theinducer assembly and connect to the port on the collector box.Trim off any excess tube to avoid sags or kinks in the tube.S Rotate the vent elbow to the desired position and tighten theclamp 15 in.-lbs.S Refer to Condensate Drain section for information how to installthe condensate drain.59TP5A13