Getting Started with vFabric Hyperic v.5.7 - VMware

2. Run the setup_from_properties_file.sh script in /opt/hyperic/hyperichqee-installer:Note: You must run setup_from_properties_file.sh as root, or as the "hyperic"user.$ sh setup_from_properties_file.sh3. After setup is complete, you can start the vFabric Hyperic Server. For instructions, seeStart and Stop vFabric Hyperic Server.Configure LicensePerform the steps in Install or Configure vFabric Hyperic License before starting the vFabricHyperic Server.Start the vFabric Hyperic Serveryum installs vFabric Hyperic Server to start automatically each time your RHEL VM is booted.The init script is /etc/init.d/hyperic-hq-server.Follow these steps to start the vFabric Hyperic server manually:1. Log in to the RHEL VM as root.2. Open a terminal window and run the init script:/etc/init.d/hyperic-hq-server startThe first time vFabric Hyperic Server starts it may take a few minutes to initialize;subsequent startups will be faster.3. After vFabric Hyperic Server starts, invoke the vFabric Hyperic user interface in yourbrowser:http://host:7080Where host is the hostname of the RHEL VM on which you just installed vFabricHyperic Server. #* If your browser is on the same computer on which you installedvFabric Hyperic Server, you can use localhost rather than the name of the computer.4. Log in using the default administration username/password of hqadmin/hqadmin; besure to change the password after you log into the vFabric Hyperic UI.After Installing vFabric Hyperic ServerFor information about installing the vFabric Hyperic Agent, see Install vFabric HypericAgent RPM.59