Alibre Design

Chapter 7 - Feature Creation7. Specify the Wall Thickness by entering values for the Side 1 and Side 2 wall thicknesses.Specifying a Side 1 value will create or remove material inward from the sketch, and a Side 2value will create or remove material outward from the sketch.8. Click OK to create the thin wall extrusion.7.4 Revolve Boss and Revolve CutAlthough the revolve boss and revolve cut features are different in end result, the steps used tocreate them are identical.Revolve features, also referred to as revolutions, either create or remove material by revolving asketch around a centerline.7.4.1 Revolve Boss and Revolve Cut FeaturesRevolve boss and cut features require a closed sketch see "Open and Closed Sketches" on page104.‣ To create a revolve boss or cut:1. With a sketch still active, select the Revolve Boss or the Revolve Cut tool from thePart Modeling toolbar; or from the Feature menu, select Boss > Revolve or Cut > Revolve.The Revolve Boss or the Revolve Cut dialog box appears.155