Alibre Design

Chapter 7 - Feature Creation2. Select the Faces to Draft.3. Select the Neutral Plane. A reference plane or an existing face can be used as the NeutralPlane.4. Specify the draft Angle.5. If necessary, check the Outward option to create the draft in the opposite direction.6. Click OK to create the draft.7.12 HolesHole features create standard holes, e.g. counter bored or counter sunk holes, in a part. You placehole features on planar faces and then place dimensions or constraints on the hole center to positionthe hole as required. In addition, you can add thread information, which can be shown on drawings.‣ To create a hole:1. Select the Hole tool from the Part Modeling toolbar; or from the Feature menu selectHole; or right-click and select Add Hole from the pop-up menu. The Hole dialog box appears.2. Select the Start surface. A reference plane or planar face can be used as the start surface.Note: You can place multiple holes simultaneously. With the Hole dialog box open, just clickagain on the start surface to place another hole.176