Installation Manual - Fireplaces

Installation (for qualified installers only) 21Optional Wall Switch or Thermostat InstallationDo not connect 110-120 VAC to the gas control valve or wiring system of this fireplace. The switch andwiring must be installed by a qualified installer.This fireplace includes an optional wall switch (with wire)to operate the fireplace burner without accessing theinternal on/off switch. A thermostat may be used instead.Route the wire from inside the fireplace, through thegrommet on either side of the fireplace near the gas inlet(see at right) to the switch. The wall switch (or thermostat)may bypass the fireplace on/off switch or be installed inparallel or series configuration (see below).OPTIONAL WALL SWITCH(included with fireplace)Place "WARNING"label on switch cover.Caution:Note:Warning:Label all wires prior to disconnection whenservicing controls. Wiring errors can causeimproper and dangerous operation.When using a GreenSmart remote, use thereceiver for on/off operation (do not use a wallswitch or thermostat).Make sure all wiring is secure and does notcontact hot or moving components.Parallel ConnectionThermostat / ExternalSwitch ONThermostat / ExternalSwitch OFFSeries ConnectionOn / Off SwitchONOn / Off SwitchOFFHeater is ON Heater is ON Thermostat /External Switch ONHeater is ON Heater is OFF Thermostat /External Switch OFFOn / Off SwitchONHeater is ONHeater is OFFOn / Off SwitchOFFHeater is OFFHeater is OFFTo wire the heater in parallel, follow the directions below: To wire the heater in series, follow the directions below:abaOn / Off SwitchOn / Off SwitchbThermostat(or External Switch) WirescThermostat(or External Switch) Wiresc© Travis Industries 4081126 100-01210_000