Installation Manual - Fireplaces

Finalizing the Installation (for qualified installers only) 574 Remove the pilot orifice following the instructions below. Replace with the propane pilot orificeaLift the pilot hoodoff the pilotcRemove the orifice and replace with the LP orifice. Screw theorifice all the way in and replace the pilot hood.assembly.Orifice Identification:LP (Propane) OrificebUse a hex wrench tounscrew the orifice.3535NG (Natural Gas) Orifice625/32" HexNOTE: when re-attaching,this pin lines up with thenotch in the pilot hood.5 Replace the firebox components. Install the logs and embers. Replace the glass.6 Remove and discard the screws (see “a” below) holding the stock regulator in place (see “b” below).Remove the stock regulator and gasket (see “c” below). Place the LP regulator in place, makingsure the pre-fitted gasket (see”c” below) is in place. NOTE: There is a label on the base of theregulator knob indicating regulator type (NG or LP). Secure the regulator with the screws includedwith the regulator – tighten to 25 lb-in of torque. Place the included label on the valve body where itcan be easily seen to insure proper identification. NOTE: Leak test this area after the heater isinstalled, gas is connected, and the main burner is lit.aT-20 Torx orbSlotted Screwdrivercd7 Make the gas line connection, bleed the gas line (if applicable), start the heater and thoroughly leaktestall gas connections and the gas control valve.© Travis Industries 4081126 100-01210_000