Installation Manual - Fireplaces

More documents

Recommendations

Info

56 Finalizing the <strong>Installation</strong> (for qualified installers only)3 Follow the directions below to replace the orifice.aSlide the air shutters allthe way to the right.bRemove and discard the front burnergasket (used only for NG installations)Front BurnerOrificeRearBurnerOrifice1/2" WrenchdApply thread sealant to the LPorifices prior to installation. Usethe chart below to identify thecorrect orifices.cUse a 1/2" open end wrenchto unscrew the two orifices.Look here for the orifice identificatione15/16"24mmFrontRearNG#56#50LP#671.1Screw each LP orifice in so theorifice protrudes 15/16" (24mm)(indicating full insertion).Travis Industries 4081126 100-01210_000
Finalizing the <strong>Installation</strong> (for qualified installers only) 574 Remove the pilot orifice following the instructions below. Replace with the propane pilot orificeaLift the pilot hoodoff the pilotcRemove the orifice and replace with the LP orifice. Screw theorifice all the way in and replace the pilot hood.assembly.Orifice Identification:LP (Propane) OrificebUse a hex wrench tounscrew the orifice.3535NG (Natural Gas) Orifice625/32" HexNOTE: when re-attaching,this pin lines up with thenotch in the pilot hood.5 Replace the firebox components. Install the logs and embers. Replace the glass.6 Remove and discard the screws (see “a” below) holding the stock regulator in place (see “b” below).Remove the stock regulator and gasket (see “c” below). Place the LP regulator in place, makingsure the pre-fitted gasket (see”c” below) is in place. NOTE: There is a label on the base of theregulator knob indicating regulator type (NG or LP). Secure the regulator with the screws includedwith the regulator – tighten to 25 lb-in of torque. Place the included label on the valve body where itcan be easily seen to insure proper identification. NOTE: Leak test this area after the heater isinstalled, gas is connected, and the main burner is lit.aT-20 Torx orbSlotted Screwdrivercd7 Make the gas line connection, bleed the gas line (if applicable), start the heater and thoroughly leaktestall gas connections and the gas control valve.© Travis Industries 4081126 100-01210_000
Page 1 and 2:
564 SSGreenSmartFireplaceTested and
Page 3 and 4:
Table of Contents 3IntroductionOver
Page 5: Safety Warnings (continued):Safety
Page 10: 10 Installation (for qualified inst
Page 13 and 14: Installation (for qualified install
Page 19 and 20: Gas Line LocationRight Side Gas Inl
Page 25 and 26: Intake Restrictor AdjustmentInstall
Page 33 and 34: Hearth RequirementsInstallation (fo
Page 41 and 42: Mantel RequirementsCombustible Mant
Page 45 and 46: Finalizing the Installation (for qu
Page 51 and 52: Left Log InstallationFinalizing the
Page 55: Finalizing the Installation (for qu
Page 59 and 60: Grill InstallationOptional Equipmen
Page 61 and 62: Optional Equipment (for qualified i
show all

Installation Manual - Fireplaces

Create successful ePaper yourself

Delete template?

Save as template?