VersaLASER® (VLS) User Guide VLS2.30, VLS3.50
VersaLASER® (VLS) User Guide VLS2.30, VLS3.50
VersaLASER® (VLS) User Guide VLS2.30, VLS3.50
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
• Dampen a cotton swab or cotton cloth with soap solution and clean the Y axis v-groove shown below.<br />
Slide the X-Axis Arm toward the front or rear of the device as necessary to gain access to the entire<br />
length of the Y-axis v-groove.<br />
Main Enclosure<br />
• Clean the glass Top/Front door with a non-abrasive cotton cloth, paper towel or facial tissue and window<br />
cleaner. The top window is made out of glass; therefore, do not use abrasive cleaning clothes because<br />
they will scratch the glass. Also, do not use abrasive chemicals that will damage the glass.<br />
• Use a soft cloth dampened with the soap solution to clean the enclosure. Do not use alcohol, acetone or<br />
any other harsh chemical as these will damage the paint.<br />
Optics<br />
A visual inspection of the #2 and #3 mirrors, beam window and focus lens should be performed at least once<br />
a day.<br />
CAUTION: Do not clean an optic that appears clean. Excessive cleaning can damage the optical<br />
coatings. To prevent contamination, wash your hands thoroughly before handling and cleaning any optic.<br />
Try not to touch the optical surfaces with your fingers, handle optics only by the edge or optical housing.<br />
Fingerprints can damage the optical coatings.<br />
Never clean any optic right after engraving or cutting because the optic may be hot and the cool lens cleaning<br />
solution may thermally shock the optic and crack it.<br />
#2 Mirror<br />
To gain access to the #2 mirror rotate the X axis rail cover up and out of the way. Locate the #2 Mirror Holder<br />
handle on the left end of the rail (red) and gently slide it out of the holder. It is held in place by magnets so you<br />
may feel a slight resistance as you are sliding it out.<br />
65