ENGLISH - Geha GmbH

Read this first
Minimum required setting screen
When you start the projection for the first time, the minimum required setting screen for projection will be displayed.
� INITIAL SETTING
1. Select the required language setting by pressing
I H, then press the ENTER button.
INITIAL SETTING
ENGLISH
PLEASE SELECT LANGUAGE
SELECT
ENTER
2. Select the minimum required settings to start the
projection.
� Press the RETURN button to return to the language
setting menu.
� Press F G to move through the menu items.
� Press I H to select the required setting.
� Press the ENTER button to complete the setting and
start the projection.
INITIAL SETTING
INSTALLATION
FRONT/DESK
HIGH ALTITUDE MODE OFF
SWITCH TO HIGH ALTITUDE MODE "ON" IF OVER 1400m(4593Ft).
SELECT
RETURN
ENTER
INSTALLATION
Select the required installation method.
FRONT/DESK
FRONT/CEILING
REAR/DESK
REAR/CEILING
Setting on a desk/floor and
projecting from front
Mounting on the ceiling and
projecting from front
Setting on a desk/floor and
projecting from rear
Mounting on the ceiling and
projecting from rear
HIGH ALTITUDE MODE
If you use the projector at high elevation, the HIGH
ALTITUDE MODE setting need to be ON to set the fan
speed high.
� OFF The fan speed is low.
� ON The fan speed is high.
NOTE:
• At 1 400 - 2700 m (4 593 - 8 858 ft) above sea level,
the setting must be ON.
• The loudness of fan noise depends on the HIGH
ALTITUDE MODE setting.
NOTE:
� Once you finish the minimum requirement setting, it will not be displayed again unless the projector is
initialised. See “INITIALIZE ALL” on page 45.
� You can change the each setting from the main menu. See “Menu Navigation” on page 32.
ENGLISH - 13
Preparation