ENGLISH - Geha GmbH

PROJECTOR SETUP menu
Remote control Control panel
� See “Navigating through the menu” on page 34.
� See “Main menu and Sub-menu” on page 32.
STATUS
You can see the status of the projector about the
following items.
Items Description
� SIGNAL
NAME Projecting signal name
FREQUENCY Projecting signal frequency
� RUNTIME
PROJECTOR Duration of projector used time
LAMP Duration of lamp used time
� REMAINING FILTER
QUANTITY Quantity of filter remaining
COMPUTER2 SELECT
You can switch the function of the COMPUTER2 IN/
1OUT terminal.
� INPUT COMPUTER2 IN
� OUTPUT COMPUTER1 OUT
NO SIGNAL SHUT-OFF
You can set the timer to switch off the power of the
projector after a certain period of time automatically
when no signal is detected. Press I H to select the
required period from 15 to 60 minutes at intervals of
5 minutes.
DISABLE
FG FG
15 MIN. 60 MIN.
FG FG
20 MIN. 55 MIN.
FG FG
25 MIN. 50 MIN.
FG FG
30 MIN. 45 MIN.
FG FG
35 MIN. IH 40 MIN.
INITIAL START UP
You can select how the projector start when the mains
lead is connected.
Options Description
LAST MEMORY
Start as the same mode as the
last switched off.
STANDBY Always start in standby mode.
ON
Always start in projecting
mode.
ENGLISH - 43
Settings