You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Basic Operation<br />
Switching the projector on/off<br />
Power indicator<br />
The power indicator informs you the status of the power.<br />
� When the LAMP or TEMP indicator is flashing, you cannot switch on the power. See “TEMP, LAMP and FILTER<br />
Indicators” on page 49.<br />
<strong>ENGLISH</strong> - 24<br />
Indicator status Status<br />
No illumination or flashing The MAIN POWER is switched off.<br />
RED<br />
GREEN<br />
ORANGE<br />
Power indicator<br />
Lit<br />
Flashing<br />
The MAIN POWER is switched on and the projector is in standby mode.<br />
When the LAMP or TEMP indicator is flashing, not available to switch on the power.<br />
The power is switched off. (When NETWORK STANDBY in NETWORK menu or IN<br />
STANDBY MODE of AUDIO SETTING in PROJECTOR SETUP menu is set to ON). Press<br />
the power button to start the projection.<br />
Flashing The power is switched on and the projector is getting ready to project.<br />
Lit Projecting.<br />
Lit<br />
The power is switched off and the projector is cooling the lamp. The indicator will light or flash,<br />
and start the projection after a short time.<br />
Flashing The power is switched on again when cooling the lamp and recovering to projection mode.<br />
NOTE:<br />
• If the projector is switched on again while the internal cooling fan is still operating by the internal power supply, it may take<br />
a while to start the projection.<br />
• The electric consumption in standby mode is 4 W.