QlikView Reference Manual.pdf - QlikCommunity - QlikView

Debugger
The Script Debugger
Running the script in the debugger can make it a lot easier to identify script errors. The debugger makes it
possible to monitor every script statement and examine the variable values while the script is executed.
The script is displayed in the window in the upper half of the debugger. The progress of the script execution
is marked with a yellow bar. Break points can be inserted by clicking on the row numbers and removed by
clicking a second time. Remove all breakpoints by clicking the Clear button. When a breakpoint is encountered,
script execution is halted until instructed to proceed.
The statement being currently executed is displayed in the window in the middle.
Status codes and any script errors are displayed in the window to the bottom, left. This is essentially the
same information that is displayed in the Script Execution Progress window when the script is run outside
the debugger.
The right bottom window displays all Variable (page 171) and their respective values. Variables that have
changed are colored red.
Breakpoints Breakpoints that have been set in the script window to the right can be
cleared. A breakpoint is shown as a red circle.
Clear
Clears all the breakpoints.
216