QlikView Reference Manual.pdf - QlikCommunity - QlikView

30.4 Document Properties: Server
Document Properties, Server
On this tab define certain aspects of the document's behavior when run on a QlikView Server.
Refresh Mode when Document is Updated on Server
This setting defines how an updated document on the QlikView Server will be handled.
Client initiates refresh.
If old data not kept in
server or client too old,
session will be disconnected.
Client initiates refresh.
If old data not kept in
server or client too old,
refresh will be performed
automatically
Server performs
refresh automatically,
without client action
418
Choose this option if the server should never initiate a refresh of data in the
client automatically. When a new version of the document becomes available
on the server, the client will be offered to refresh according to the preferences
set under Client Refresh Initiation Mode below. If this is not possible, either
because the client is too old (pre version 8) or if the server is set with Allow
only one copy of document in memory enabled in the QlikView Server control
panel, the session will simply be terminated.
Choose this option if it is preferred to let the client initiate a refresh of data in
the client when possible but will allow server to initiate a refresh automatically
if necessary. When a new version of the document becomes available
on the server, the client will be offered to refresh according to the preferences
set under Client Refresh Initiation Mode below. If this is not possible, either
because the client is too old (pre version 8) or if the server is set with Allow
only one copy of document in memory enabled in the QlikView Server control
panel, the refresh will be performed automatically by the server.
This is the option to choose if you prefer to always let the server initiate a
refresh of data in the client automatically. When a new version of the document
becomes available on the server, the data in the client will be refreshed.