QlikView Reference Manual.pdf - QlikCommunity - QlikView

Layout In this group you define how QlikView should display the text or foreground
image within the text object area.
Horizontal Alignment
The text can be horizontally left-aligned, centered or right-aligned within the
text object.
Vertical Alignment
The text can be vertically top-aligned, centered or bottom-aligned within the
text object.
Image Stretch
This setting describes how QlikView formats a foreground image to fit in the
text object area. There are four alternatives.
542
No Stretch
If this option is selected, the image will be shown as is without any stretching.
This may cause parts of the picture to be invisible or only part of the text
object to be filled.
Fill
If this option is selected, the image will be stretched to fit the text object area
without bothering about keeping the aspect ratio of the image.
Keep Aspect
If this option is selected, the image will be stretched as far as possible to fill
the text object area while keeping the aspect ratio. This typically results in
areas either on both sides of or above and below which are not filled by the
image.
Fill with Aspect
If this option is selected, the image will be stretched to fill the text object area
in both directions while keeping the aspect ratio. This typically results in cropping
of the image in one direction.
Text Margin
With this setting you may create a margin between the outer borders of the
text object and the text itself. The width of the margin can be specified in mm,
cm, inches (", inch), pixels (px, pxl, pixel), points (pt, pts, point) or docunits
(du, docunit).