QlikView Reference Manual.pdf - QlikCommunity - QlikView

ing. This may cause parts of the picture to be invisible or only part of the cell
to be filled.
Fill
If this option is selected, the image will be stretched to fit the cell without
keeping the aspect ratio of the image.
Keep Aspect
If this option is selected, the image will be stretched as far as possible to fill
the cell while keeping the aspect ratio.
Fill with Aspect
If this option is selected, the image will be stretched to fill the cell in both
directions while keeping the aspect ratio. This typically results in cropping of
the image in one direction.
Accumulation By choosing between the settings in this group, you decide whether the values
in the chart should be accumulated or not. In an accumulated chart, each yvalue
is added to the y-value of the following x-value. In an accumulated bar
chart showing the sum of sales per year, e.g. the value of the year 1996 is
added to that of the year 1997. If your chart contains several expressions,
select the expression which values to be accumulated in the Expressions list.
Accumulation is not available for pivot tables.
No Accumulation
If this option is selected, the y-values of the selected chart expression will not
be accumulated.
Full Accumulation
If this option is selected, each y-value will accumulate all previous y-values of
the expression. See above under Accumulation.
Accumulate n Steps Back
By entering a number in the box, you set the number of y-values in the expression
to be accumulated. See above under Accumulation.
Total Mode This group is enabled for the selected expression. There are three possible settings:
No Totals
Totals are not calculated for the selected expression.
Expression Total
The total of the expression evaluated on the next level. For example, if an
expression generates the average monthly salary for a number of employees,
the Expression Total will generate the total average of all the salaries.
F(x) of Rows
If this option is selected, the individual values of each data point (each bar in
a bar chart, each row in a straight table etc.) for the selected expression will be
aggregated using the aggregation function selected from the drop-down list
(typically summed up). F(x) of Rows is not available for pivot tables.
Bar Border Width Specifies the width of the border line around bars plotted by this expression in
bar and combo charts. The value can be specified in mm, cm, inches (", inch),
pixels (px, pxl, pixel), points (pt, pts, point) or docunits (du, docunit).
Expressions as Legend When several expressions are used, this option displays a legend showing the
expressions and their corresponding colors next to the chart.
616