SDM-8400 HIG.book - Comtech EF Data
SDM-8400 HIG.book - Comtech EF Data
SDM-8400 HIG.book - Comtech EF Data
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
4.3 Powering Up the Unit<br />
4.3.1 Connecting to the Power Source<br />
Hardware Installation<br />
NOTE: Information about the power supply is provided on “Power Supply” on<br />
page 5-10.<br />
A removable power cord is supplied with the unit, either:<br />
• 115VAC North American type, or<br />
• 240VAC European Schuko type (see Figure 4-2).<br />
115VAC North American type<br />
Figure 4-2: Power Cords for <strong>SDM</strong>-<strong>8400</strong> UAC Unit<br />
240VAC European Schuko type<br />
To connect a UAC unit to its power source:<br />
1. Connect the female end of the factory supplied power cord to the AC power inlet,<br />
located at the rear of the <strong>SDM</strong>-<strong>8400</strong> chassis.<br />
2. Plug the male end of the power cable into an AC power outlet (100-240 VAC, 50/60<br />
Hz) with a protective earthing connection in good condition.<br />
NOTE: The unit will begin power-up and system check immediately.<br />
Warning: Do not remove the cover of the <strong>SDM</strong>-<strong>8400</strong>. The <strong>SDM</strong>-<strong>8400</strong> unit<br />
contains no user-serviceable parts. Only a qualified technician approved by<br />
Memotec is authorized to open the unit.<br />
Memotec 4-5