SDM-8400 HIG.book - Comtech EF Data
SDM-8400 HIG.book - Comtech EF Data
SDM-8400 HIG.book - Comtech EF Data
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
NetPerformer <strong>SDM</strong>-<strong>8400</strong> Hardware Installation Guide<br />
5.5 Power Supply<br />
The power supply is located on the right side when the <strong>SDM</strong>-<strong>8400</strong> unit is viewed from the<br />
rear (see Figure 5-1).<br />
NOTE: For information about the factory-supplied power cable and connection to the<br />
power source, turn to “Connecting to the Power Source” on page 4-5.<br />
• AC power inlet (IEC 320)<br />
• Voltage: Autosensing 100-240 VAC<br />
• Frequency: 50/60 Hz<br />
• Current: 0.7 A at 100 V and 0.4 A at 240 V<br />
• Maximum power consumption: 16 Watts (55 BTU/hour)<br />
• Removable power cord (North American or Schuko European type).<br />
NOTE: There is no power switch. Remove the power cord to turn the unit off.<br />
Warning: Do not remove the cover of the <strong>SDM</strong>-<strong>8400</strong>. The <strong>SDM</strong>-<strong>8400</strong> unit<br />
contains no user-serviceable parts. Only a qualified technician approved by<br />
Memotec is authorized to open the unit.<br />
5-10 Memotec