CPNMD Interconnect Pipeline Specs 8-1-12 - Garney Construction

All Work and existing facilities affected by cutting operations shall be restored
with new materials, or with salvaged materials acceptable to District
Representative, to obtain a finished installation with the strength, appearance,
and functional capacity required. If necessary, entire surfaces shall be patched
and refinished.
16. HAZARDOUS ENVIRONMENTAL CONDITIONS AT SITE. No Hazardous
Environmental Conditions at the Site in areas that will be affected by the Work
are known to the District.
16.01. Previously Unidentified Hazardous Environmental Conditions. If, during
the progress of the Work, previously unidentified Hazardous Environmental
Conditions are identified, Contractor shall stop work in the affected area and
immediately notify the District and District Representative in accordance with the
requirements in the General Conditions. At the District’s discretion, the District
may instruct the Contractor to engage an abatement Subcontractor qualified to
perform abatement of the suspected Hazardous Environmental Condition
identified, to verify the materials and, if necessary, encapsulate, enclose, or
remove and dispose of all ACM, Metal Bearing Protective Coatings, Paints, and
Linings, Contaminated Environmental Media, and/or other Hazardous
Substances in accordance with current regulations of the Environmental
Protection Agency and the U. S. Department of Labor - Occupational Safety and
Health Administration, the applicable state regulating agency, and any local
government agency. Payment for such work will be made by Change Order.
17. CLEANING UP. Contractor shall keep the premises free at all times
from accumulations of waste materials and rubbish. Contractor shall provide
adequate trash receptacles about the Site and shall promptly empty the
containers when filled.
Construction materials, such as concrete forms and scaffolding, shall be
neatly stacked by Contractor when not in use. Contractor shall promptly remove
splattered concrete, asphalt, oil, paint, corrosive liquids, and cleaning solutions
from surfaces to prevent marring or other damage.
Volatile wastes shall be properly stored in covered metal containers and removed
daily.
Wastes shall not be buried or burned on the Site or disposed of into storm drains,
sanitary sewers, streams, or waterways. All wastes shall be removed from the
Site and disposed of in a manner complying with local ordinances and antipollution
laws.
(CPNMD )
(INTERCONNECT PIPELINE ) 01015
(167558.0200 ) -6-
(08/01/12 )