*Voir et Entendre n'a jamais eu autant de sens - Pioneer

Install Your Flat Panel TV
02
2.1.1 Check the Location for Suitability
When choosing the location for your panel, there are several factors you need to keep in mind. The installation
site should be out of direct sunlight and have sufficient ventilation around the flat panel TV to allow cooling. The
diagram below is an example of a stand-mounted panel with proper ventilation.
English
Over 50 cm
(19 11/16 inches)
Over
10 cm
(3 15/16
inches)
The distance behind and above the panel
changes depending on your choice of mount.
Consult with your dealer or professional
installer for proper ventilation.
Use the checklist below to judge possible installation sites.
Sufficient ventilation
Safe from excessive vibrations
Away from air conditioners
Free of moisture or dampness
No danger of splashing water
Route cords and cables safely
No danger of power overloads
Separate from other IR equipment
Protected from hits or shocks
Distance from heat sources
Out of direct sunlight
Away from strong lighting sources
For specific cautions and safety information, refer to “7.2 Physical Location & Temperature Considerations” and
“7.7 Safety Precautions.”
2.1.2 Lift and/or Move Your Panel (the How To’s)
This flat panel TV is built for endurance but because of the technology, the panel must be handled with care. Use
the handles attached to the rear of the flat panel TV to lift the unit. To avoid flexing or twisting the unit, you need
at least two people to lift and move the panel. Do not move the flat panel TV by holding only a single handle or by
dragging the panel by its handles.
Use the handles to move the panel.
Do not move the panel by holding the
speaker or speaker brackets.
Note: Do not use the handles to hang the flat panel TV or as anchors to prevent the panel from slipping or tipping
after it is mounted.
15
En