1954 Cadillac - GM Heritage Center

MAKI OF CAR
AMA Consolidated Specification Questionnaire
CADILLAC
SODY—GENERAL DEFINITIONS
MODEL YIAR L25JL
Pag. H
*«v. e-j;
NOTE: Included in the dlm«.-uion definitions lilted on thi* and the following pages are those which have bean proposed for adoption by the SAE
Th«i« -are '.ndicated by a number following the type of dimension, e.g., L 3. Additional dimensions have been add«d by the AMA Specifications Sod»
Sub-Comrr.irtee for inclusion in fha Questionnaire. These ora shown by on (additional letter, a.g., HA. Tha dimensions ora davalopad from the foMowlna
boile poind:
MOOIL
1. Front and rear teat "A" poind are taken 5" forward of vertical tangent to teat back 15' from center of body.
2. Front leaf it in the r»ar position.
3. Loaded position—5 passengers, front 300 lb., rear 450 lb., include* spore wheel, tire and tools, and full complement of gas, oil water ere
and tires to recommended pressure, etc.
4. C. L (centerline).
5. 0. I. O. (daylight opening, exposed glass dimension).
6. Ramp breakover angle (page 20-A) is the supplement of the included ramp angle (160° minus the included ramp angle) over which a car
can pass without hanging up.
6267
6237D
BODY—TRUNK OPENING DIMENSIONS
TA—Width acroti th« top
Tl—Width acroti th« bottom
TC—Diagonal dimension at CI
from top of opening to bottom
TO—Vertical height of opening (floor
to top, Inside edge of opening)
Tl-Ma*. horizontal depth (forward
from vertical pro|ectlon of Inside
edge of opening)
Petition of spare tire stowage
Method of holding lid open
6267S
6219 6019 75
N.A.
N,A.
N.A.
N.A.
N.A.
6267
VERTICAL
COUNTER BALANCED SPRING