VL2000 Wash Luminaire User's Manual - Avantgarde-technik.de
VL2000 Wash Luminaire User's Manual - Avantgarde-technik.de
VL2000 Wash Luminaire User's Manual - Avantgarde-technik.de
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
B2M1<br />
Blue<br />
SAct<br />
B2M2<br />
Ambr<br />
NoSn<br />
B2M2<br />
Ambr<br />
SAct<br />
BRD1<br />
NO<br />
COMM<br />
BRD2<br />
NO<br />
COMM<br />
LAMP<br />
STRK<br />
FAIL<br />
PAN<br />
ENCR<br />
FAIL<br />
TROUBLESHOOTING AND MAINTENANCE : TROUBLESHOOTING A<br />
Table A-1: Troubleshooting Gui<strong>de</strong> (Continued)<br />
Error Display Description Possible Cause and Remedy<br />
Aux Board 2, Motor 1,<br />
Blue,<br />
Sensor Always Active<br />
Aux Board 2, Motor 2,<br />
Amber,<br />
Sensor Not Found<br />
Aux Board 2, Motor 2,<br />
Amber,<br />
Sensor Always Active<br />
Aux Board 1<br />
Communication Failure<br />
Aux Board 2<br />
Communication Failure<br />
Blue power not connected and Blue<br />
aligned with sensor<br />
- Connect Blue power at motor<br />
Amber power not connected, motor<br />
not moving<br />
- Connect Amber power at motor<br />
Amber sensor not connected<br />
- Connect Amber sensor<br />
Amber movement restricted or<br />
impe<strong>de</strong>d<br />
- Remove obstruction<br />
Amber sensor is faulty<br />
- Replace color sensor assembly<br />
Aux Board 2 is faulty<br />
Replace aux board<br />
Amber power not connected, and<br />
amber aligned with sensor<br />
- Connect Amber power at motors<br />
Aux input connector (J5) not<br />
connected to either aux board<br />
- Connect aux input connector (J5)<br />
to either aux board<br />
Jumper/bridge connector (J1)<br />
between aux boards not connected<br />
- Install jumper/bridge connector<br />
(J1) between aux boards<br />
Aux input connector (J5) not<br />
connected to either aux board<br />
- Connect aux input connector (J5)<br />
to either aux board<br />
Jumper/bridge connector (J1)<br />
between aux boards not connected<br />
- Install jumper/bridge connector<br />
(J1) between aux boards<br />
Lamp Strike Failure Lamp failed to strike after repeated<br />
attempts<br />
- Replace lamp<br />
Pan Enco<strong>de</strong>r Failure Main board pan/tilt connector (J9)<br />
disconnected<br />
- Connect main board pan/tilt<br />
connector (J9)<br />
Pan motor disconnected<br />
- Connect pan motor power<br />
02.9671.0001 E 17-Sep-02 87
Change language