SERVICE SPECIFICATIONS

More documents

Recommendations

Info

A46DE AUTOMATIC TRANSMISSION - REAR PLANETARY GEAR (A46DE) AT4791 AT4792 AT4793 AT6252 AT4795 (b) Remove the planetary ring gear. (c) Remove the race from the ring gear. 6. REMOVE OIL SEAL RING FROM INTERMEDIATE SHAFT Using a screwdriver, remove the oil seal ring. AT-71 7. REMOVE OIL SEAL RINGS FROM OUTPUT SHAFT Remove the three oil seal rings. REAR PLANETARY GEAR AND OUTPUT SHAFT INSPECTION 1. CHECK OUTPUT SHAFT BUSHING Using a dial indicator, measure the inside diameter of the output shaft bushing. Maximum inside diameter: 18.08 mm (0.7118 in.)
AT-72 A46DE AUTOMATIC TRANSMISSION - REAR PLANETARY GEAR (A46DE) AT4796 AT6252 AT4793 AT4797 If the inside diameter is greater than the maximum, replace the output shaft. 2. MEASURE PLANETARY PINION GEAR THRUST CLEARANCE Using a feeler gauge, measure the planetary pinion gear thrust clearance. Standard clearance: 0.20 - 0.50 mm (0.0079 - 0.0197 in.) If the clearance is nonstandard, inspect the planetary gear thrust washer. If necessary, replace the planetary gear assembly. REAR PLANETARY GEAR AND OUTPUT SHAFT ASSEMBLY 1. INSTALL OIL SEAL RINGS (a) Coat the three oil seal rings with ATF. (b) Contract the oil seal rings, and install them onto the output shaft. NOTICE: Do not spread the ring ends too much. HINT: After installing the oil seal rings, check that they rotate smoothly. 2. INSTALL NEW OIL SEAL RING Coat a new oil seal ring with ATF and install it to the intermediate shaft. NOTICE: Do not spread the ring too much. HINT: After installing the oil seal ring, check that it rotates smoothly. 3. INSTALL PLANETARY RING GEAR (a) Coat the race with petroleum jelly and install it onto the intermediate shaft. Race diameter: Inside mm (in.) Outside mm (in.) Race 21.6 (0.850) 41.4 (1.630)
Page 1 and 2:
SERVICE SPECIFICATIONS SERVICE DATE
Page 3 and 4:
Output Shaft End play 0.3 - 0.9 mm
Page 5 and 6:
EQUIPMENT Feeler gauge Vernier cali
Page 7 and 8:
Rear Planetary Gear Planetary pinio
Page 9 and 10:
AT-10 PREPARATION SST (SPECIAL SERV
Page 11 and 12:
IN-10 INTRODUCTION - ABBREVIATIONS
Page 13 and 14:
GENERAL SPECIFICATIONS Type of Tran
Page 15 and 16:
GENERAL SPECIFICATIONS Type of Tran
Page 17 and 18:
2. FUNCTION OF COMPONENTS COMPONENT
Page 19 and 20:
2 or L Position 2nd Gear L Position
Page 21 and 22:
4. ELECTRONIC CONTROL SYSTEM The el
Page 23 and 24:
2. FUNCTION OF COMPONENTS COMPONENT
Page 25 and 26:
2 or L Position 2nd Gear L Position
Page 27 and 28:
ECTS Throttle Position Sensor Idli
Page 29 and 30:
Manual Valve Lever Shaft ♦ Oil Se
Page 31 and 32:
A46DE AUTOMATIC TRANSMISSION - COMP
Page 33 and 34:
Page 35 and 36:
Page 37 and 38:
SST A46DE AUTOMATIC TRANSMISSION -
Page 39 and 40:
Page 41 and 42:
Manual Valve Lever Shaft ♦ Oil Se
Page 43 and 44:
A46DF AUTOMATIC TRANSMISSION - COMP
Page 45 and 46:
Page 47 and 48:
Page 49 and 50:
SST A46DF AUTOMATIC TRANSMISSION -
Page 51 and 52:
Page 53 and 54:
AT-24 COMPONENT PARTS GENERAL NOTES
Page 55 and 56:
AT-26 Front Side Bushing A46DE AUTO
Page 57 and 58:
AT-28 A46DE AUTOMATIC TRANSMISSION
Page 59 and 60:
AT-26 Front Side Bushing A46DF AUTO
Page 61 and 62:
AT-28 A46DF AUTOMATIC TRANSMISSION
Page 63 and 64:
AT-30 AT4751 AT4752 A46DE AUTOMATIC
Page 65 and 66:
Page 67 and 68:
AT-34 AT4578 AT4765 Retainer Retain
Page 69 and 70:
AT-36 Hold Lock A46DE AUTOMATIC TRA
Page 71 and 72:
AT-30 AT4751 AT4752 A46DF AUTOMATIC
Page 73 and 74:
AT-32 A46DF AUTOMATIC TRANSMISSION
Page 75 and 76:
AT-34 AT4881 AT4765 AT4578 AT4765 R
Page 77 and 78:
AT-36 Hold Lock A46DF AUTOMATIC TRA
Page 79 and 80:
Page 81 and 82:
AT-40 Front Rear A46DE AUTOMATIC TR
Page 83 and 84:
O/D Planetary Ring Gear Race ♦ No
Page 85 and 86:
A46DF AUTOMATIC TRANSMISSION - OVER
Page 87 and 88:
A46DF AUTOMATIC TRANSMISSION - OVER
Page 89 and 90:
SST A46DE AUTOMATIC TRANSMISSION -
Page 91 and 92:
SST SST AT4650 AT6246 AT4838 A46DE
Page 93 and 94: AT-42 Front Clutch Front Clutch Pis
Page 95 and 96: AT-44 A46DF AUTOMATIC TRANSMISSION
Page 97 and 98: AT-46 AT4687 AT4688 Rear Front SST
Page 99 and 100: AT-48 SST A46DE AUTOMATIC TRANSMISS
Page 101 and 102: AT-50 SST AT4696 AT4838 AT4695 A46D
Page 103 and 104: Snap Ring ♦ Non-reusable part A46
Page 105 and 106: A46DF AUTOMATIC TRANSMISSION - REAR
Page 107 and 108: A46DF AUTOMATIC TRANSMISSION - REAR
Page 109 and 110: SST A46DE AUTOMATIC TRANSMISSION -
Page 111 and 112: SST AT4704 AT4839 SST A46DE AUTOMAT
Page 113 and 114: AT-52 Oil Seal Ring Snap Ring ♦ N
Page 119 and 120: AT-58 SST A46DE AUTOMATIC TRANSMISS
Page 121 and 122: AT-60 SST AT4778 AT4783 AT4777 A46D
Page 123 and 124: Center Support Non reusable part A
Page 125 and 126: SST A46DF AUTOMATIC TRANSMISSION -
Page 127 and 128: A46DF AUTOMATIC TRANSMISSION - NO.
Page 129 and 130: A46DE AUTOMATIC TRANSMISSION - PLAN
Page 131 and 132: AT-62 Free Hold Front Side Retainer
Page 133 and 134: AT-64 Open End AT4773 AT4769 Free H
Page 135 and 136: AT-66 A46DE AUTOMATIC TRANSMISSION
Page 137 and 138: AT-68 Hold Free 5. CHECK OPERATION
Page 141 and 142: AT-68 Hold Free 5. CHECK OPERATION
Page 143: AT-70 A46DE AUTOMATIC TRANSMISSION
Page 147 and 148: AT-74 A46DE AUTOMATIC TRANSMISSION
Page 155 and 156: Disc ♦ Non-reusable part A46DF AU
Page 157 and 158: Pin Pin Retainer A46DE AUTOMATIC TR
Page 159 and 160: Q00434 A46DE AUTOMATIC TRANSMISSION
Page 161 and 162: Pin Pin Retainer A46DF AUTOMATIC TR
Page 163 and 164: Q00434 A46DF AUTOMATIC TRANSMISSION
Page 165 and 166: Mark Name (Color) A46DE AUTOMATIC T
Page 167 and 168: AT-80 Retainer Plug Cut-back Valve
Page 169 and 170: AT-82 RETAINERS AND PIN LOCATION Cu
Page 171 and 172: AT-84 Mark Name (Color) A46DE AUTOM
Page 173 and 174: Plug Pin ♦ Non-reusable part A46D
Page 175 and 176: RETAINERS, PIN AND CHECK BALLS LOCA
Page 177 and 178: Mark Name (Color) A46DE AUTOMATIC T
Page 179 and 180: AT-86 Plunger Sleeve Intermediate M
Page 181 and 182: AT-88 RETAINERS, CHECK BALLS AND SP
Page 183 and 184: A46DE AUTOMATIC TRANSMISSION - TRAN
Page 185 and 186: AT6267 Mark A46DF AUTOMATIC TRANSMI
Page 187 and 188: SST AT6424 AT4803 A46DF AUTOMATIC T
Page 189 and 190: A46DF AUTOMATIC TRANSMISSION - COMP
Page 191 and 192: SST SST Front A46DF AUTOMATIC TRANS
Page 193 and 194: A46DF AUTOMATIC TRANSMISSION - COMP
Page 195 and 196:
Page 197 and 198:
C4500 A46DF AUTOMATIC TRANSMISSION
Page 199 and 200:
Page 201 and 202:
COMPONENT PARTS INSTALLATION Disass
Page 203 and 204:
Manual Valve Lever Manual Valve Lev
Page 205 and 206:
Page 207 and 208:
Front A46DE AUTOMATIC TRANSMISSION
Page 209 and 210:
Race SST A46DE AUTOMATIC TRANSMISSI
Page 211 and 212:
Q00420 A46DE AUTOMATIC TRANSMISSION
Page 213 and 214:
AT6231 AT6229 A46DE AUTOMATIC TRANS
Page 215 and 216:
Page 217 and 218:
1992 TOYOTA MOTOR CORPORATION All r
Page 219 and 220:
IN-6 Fuse Equal Amperage Rating WRO
Page 221 and 222:
IN-8 INTRODUCTION - GLOSSARY OF SAE
Page 223 and 224:
IN-2 HOW TO USE THIS MANUAL To assi
Page 225 and 226:
IN-4 CAUTIONS, NOTICES, HINTS: Sl U
Page 227:
Class Diameter mm Pitch mm Specifie
show all

SERVICE SPECIFICATIONS

Create successful ePaper yourself

Delete template?

Save as template?