SERVICE SPECIFICATIONS

AT-102
AT6231
AT6229
A46DF AUTOMATIC TRANSMISSION - COMPONENT PARTS INSTALLATION (A46DF)
AT6232
Z05010
AT6230
Z07114
AT0873
(b) Connect the throttle cable to the cam.
(c) Install the seventeen bolts.
HINT: Each bolt length (mm, in.) is indicated below.
Torque: 10 N-m (100 kgf-cm, 7 ft-lbf)
Bolt length:
A bolt 25 mm (0.98 in.)
B bolt 30 mm (1.18 in.)
C bolt 47 mm (1.85 in.)
D bolt 60 mm (2.36 in.)
27. INSTALL OIL STRAINER
(a) Install a new gasket to the oil strainer.
(b) Install the oil strainer to the valve body.
(c) Install and tighten the six bolts.
Torque: 5.4 N-m (55 kgf-cm, 48 in.-lbf)
28. INSTALL OIL TUBES
Using a plastic hammer, install the two tubes into position.
NOTICE: Be careful not to bend or damage the tubes.
29. INSTALL OIL PAN
(a) Install the two magnets in the oil pan.
NOTICE: Make sure that the magnets do not interfere
with the oil tubes.
(b) Install a new gasket to the transmission case.
HINT: Align the cut part of the gasket and case.