SERVICE SPECIFICATIONS

A46DE AUTOMATIC TRANSMISSION - COMPONENT PARTS INSTALLATION (A46DE)
AT4628
Bolt
AT6216
AT4993
AT6222
Neutral
Basic
Line
Groove
AT6425
AT-105
32. INSTALL NO. 2 VEHICLE SPEED SENSOR
Install the No. 2 vehicle speed sensor with the bolt.
33. INSTALL UNION AND ELBOW
(a) Coat new two O-rings with ATF and install them
to each union.
(b) Install and tighten the union and elbow.
Torque: 34 N-m (345 kgf-cm, 25 ft-lbf)
34. INSTALL SPEEDOMETER DRIVEN GEAR
(a) Coat a new O-ring with ATF and install it to the
sleeve.
(b) Insert the driven gear into the sleeve.
(c) Install the lock plate with the bolt.
35. INSTALL PARK/NEUTRAL POSITION SWITCH
(a) Insert the park / neutral position switch onto the
manual valve lever shaft and temporarily tighten
the adjusting bolt.
(b) Install the grommet and a new lock washer,
install and tighten the nut.
Torque: 3.9 N-m (40 kgf-cm, 35 in.-lbf)
(c) Align the neutral basic line and the switch groove,
and tighten the adjusting bolt.
Torque: 5.4 N-m (55 kgf-cm, 48 in.-lbf)
(d) Bend the tabs of the lock washer.
HINT: Bend at least two of the lock washer tabs.