ECL Comfort 210/310, A275/A375 Installation Guide - Danfoss ...

Installation Guide ECL Comfort 210 / 310, application A275 / A375
DHW circuit
Overview display 1 informs about:
actual DHW temperature, controller mode, desired DHW
temperature as well as the comfort schedule of the current day.
Overview display 2 informs about:
state of the controlled components, actual DHW temperature,
(desired DHW temperature), controller mode, return temperature
(limitation value).
Dependent on chosen display, the overview displays for the DHW
circuit inform you about:
• actual DHW temperature (50.3)
• controller mode ( )
• desired DHW temperature (50 °C)
• comfort schedule of the current day(0 - 12 - 24)
• state of the controlled components (M1, P1)
• actual DHW temperature (50 °C), (desired DHW temperature (50))
• return temperature (- - °C) (limitation temperature (30))
Setting the desired temperature
Depending on the chosen circuit and mode, it is possible to enter
all daily settings directly from the overview displays (see also the
next page concerning symbols).
Setting the desired room temperature
The desired room temperature can easily be adjusted in the
overview displays for the heating circuit.
Action: Purpose: Examples:
Desired room temperature 20.5
Confirm
Adjust the desired room temperature 21.0
Confirm
This overview display informs about outdoor temperature, actual
room temperature as well as desired room temperature.
The display example is for comfort mode. If you want to change
the desired room temperature for saving mode, choose the mode
selector and select saving.
If the temperature value is displayed as
"- -" the sensor in question is not connected.
"- - -" the sensor connection is short-circuited.
Overview display 1: Overview display 2:
92 DEN-SMT/DK VI.GU.L1.02 Danfoss District Energy